Honda EU65is Mode D'emploi page 406

cap.14 EU65is 6500is 07.12.17 5:05 PM ページ14-4
2. CRANKSHAFT/BALANCER/PISTON
a. DISASSEMBLY/REASSEMBLY
Remove the crankcase cover (P. 14-1).
On reassembly, apply engine oil to the following parts:
– Crankshaft
– Camsaft
– Piston
– Connectig rod big end
– Balancer shaft
– Crankshaft and camshaft bearings
– Valve lifters
[1]
35 x 52 x 8 mm
OIL SEAL
[16]
10 mm FLANGE NUT
10 N . m (1.0 kgf . m,
7 lbf . ft)
[15]
OIL DRAIN BOLT
23 N . m (2.3 kgf . m,
17 Ibf . ft)
[14]
SEALING WASHER
Do not reuse.
[13]
14 mm O-RING
[12]
OIL LEVEL SWITCH
INSPECTION: P. 14-10
[11]
CONNECTING ROD BOLT (2)
INSTALLATION:
Apply oil to the threads of
the bolts.
TORQUE:
14 N·m (1.4 kgf·m, 10 lbf·ft)
14-4
[2]
Apply grease to the
lip of the oil seal.
6 x 12 (2)
[10]
CONNECTING
ROD CAP
[9]
BALANCER
[3]
PISTON
REASSEMBLY:
Install with the triangle
mark toward the push
rod hole.
DISASSEMBLY/
REASSEMBLY:
P. 14-5
INSPECTION:
P. 14-6, 7 and 8
[3]-1 TRIANGLE MARK
[4]
VALVE LIFTER (2)
DISASSEMBLY:
When removing, mark so that
the IN and EX sides can be
distinguished.
REASSEMBLY:
Install the lifters immediately
before installing the camshaft.
[5]
6202 BALL
BEARING
INSPECTION: P. 14-3
REPLACEMENT: P. 14-2
[6]
6207 CRANKSHAFT
BEARING
INSPECTION: P. 14-3
REPLACEMENT: P. 14-2
[8]
CRANKSHAFT
REASSEMBLY:
Push in until the bearing
touches the crankcase.
Be careful not to damage
the oil seal.
INSPECTION: P. 14-8 and 9
[7]
CAMSHAFT
INSPECTION:
P. 14-9 and 10