Honda EU65is Mode D'emploi page 282

cap.04 EU65is 6500is (Eu).qxd 07.12.17 4:46 PM ページ4-7
[3]
THROTTLE STOP SCREW
INSTALLATION: P. 4-8
[2] PILOT SCREW
REPLACEMENT: P. 4-9
[1] LIMITER CAP
REPLACEMENT: P. 4-9
[14] FLOAT
INSPECTION: P. 4-10
REASSEMBLY:
Check for smooth movement
after installation.
[13] MAIN JET
REASSEMBLY:
Clean thoroughly with
compressed air before
installation.
MAIN JET NUMBER:
#98
[4]
O-RING
[12] DRAIN SCREW
4-7
[4]
O-RING
[15]
FLOAT VALVE
SPRING
[4]
O-RING
[5] PILOT JET
REASSEMBLY:
• Clean thoroughly
compressed air before
installation.
• Lightly lubricate the O-ring
to ensure easy installation
into the carburetor body.
[8] FLOAT VALVE
REASSEMBLY:
Check for worn float valve seat, float
valve or weak spring before installation.
[8]-1
VALVE SEAT
[9] MAIN NOZZLE
REASSEMBLY:
Clean thoroughly with
compressed air before
installation.
[10] FLOAT CHAMBER
[11] SET BOLT
with
[5]-1
O-RING
[6]
CARBURETOR BODY
CLEANING: P. 4-10
[7] FLOAT PIN
[8]-2 FLOAT VALVE
[8]-3
[8]-4
REPLACE
OK
REASSEMBLY:
Install the float chamber at
the angle shown.
20°