Honda EU65is Mode D'emploi page 366

cap.11 EU65is 6500is 07.12.17 5:03 PM ページ11-6
b. REASSEMBLY
1) Install the stator collars on the stator as shown.
• Do not interchange the double notched collars with the
single notched collars.
• Connect the generator wire harness connctors to the
three terminal side as shown.
2) Clean off oil or grease from the crankshaft taper and rotor
tapered hole. Install the woodruff key on the crankshaft.
3) Install the stator while placing the generator wire harness
as shown and tighten the four 6 x 78 mm socket bolts.
<On stator reassembly>
TORQUE: 11 N . m (1.1 kgf . m, 8 lbf . ft)
<On crankcase replacement>
TORQUE: 12 N . m (1.2 kgf . m, 9 lbf . ft)
11-6
[2]
[1]
GENERATOR WIRE
STATOR COLLAR B (2)
HARNESS
[6]
THREE
TERMINAL
[5]
SIDE
STATOR COLLAR A (2)
[1]
STATOR
[2]
GENERATOR
WIRE
HARNESS
[1]
[3]
STATOR
6 x 78 mm
SOCKET
BOLT (4)
[3]
RED TAPE
[4]
STATOR
[4]
WOODRUFF
KEY