Honda EU65is Mode D'emploi page 358

cap.11 EU65is 6500is 07.12.17 5:03 PM ページ11-2
2. FAN COVER
a. DISASSEMBLY/REASSEMBLY
The fan cover can be removed with the engine in the frame.
1) Remove the following parts:
– Front cover (P. 6-1)
– Battery (P. 5-1)
– Inverter unit (P. 6-2)
– Control panel (P. 6-5)
– Fuel tank (P. 7-1)
– Recoil starter (P. 9-1)
2) Remove the 10 mm flange nuts and raise the fan cover until
the stud bolt of the bottom rubber is clear from the fan
cover by placing wooden blocks under the engine.
[1]
6 mm
FLANGE NUT (2)
8.5 N . m (0.9 kgf . m,
6.3 lbf . ft)
[7]
10 mm
FLANGE NUT (2)
6 x 23 (2)
[6]
FAN COVER
REASSEMBLY:
Install the generator harness grommet
in the cutout of the fan cover as
shown.
[6]-2
GENERATOR
HARNESS
GROMMET
11-2
6 x 12 (2)
[6]-1
CUTOUT
6 x 30 (3)
[2]
PROJECTIONS
REASSEMBLY:
Install the ground terminals so they
are held on the projections of the
fan cover.
6 x 12 (2)
[4]
6 mm SPRING NUT (5)
[5]
6 x 12
RIGHT SIDE PLATE
[2]-1
PROJECTIONS
[3]
FAN COVER
BRACKET