Front Frame - Honda EU65is Mode D'emploi

cap.09 EU65is 6500is 07.12.17 4:55 PM ページ9-5

2. FRONT FRAME

a. REMOVAL/INSTALLATION
Remove the following parts:
– Front cover (P. 6-1)
– Inverter unit (P. 6-2)
– Control panel (P. 6-5)
– Recoil starter (P. 9-1)
[9]
HARNESS
CLIP B
[8]
GENERATOR
WIRE HARNESS
9-5
[1]
ENGINE WIRE
[2]
HARNESS
WIRE HARNESS BAND (2)
[4]
INVERTER UNIT
CUSHION RUBBER (3)
[3]
FRONT FRAME
[7]
BATTERY BOX
RUBBER (4)
8 x 12 (5)
24 N . m (2.4 kgf . m, 18 lbf . ft)
[5]
SEPARATOR SEAL RUBBER A
REASSEMBLY:
Install the separator seal rubber to the
front frame securely as shown.
[5]-1
FRONT FRAME
[5]-2
SEPARATOR
[5]-3
SEAL
FAN COVER
RUBBER A
[6]
SEPARATOR SEAL RUBBER B
REASSEMBLY:
Install the separator seal rubber to the
front frame securely as shown.
[6]-1
FRONT FRAME
[6]-2
SEPARATOR
SEAL
RUBBER B