Honda EU65is Mode D'emploi page 388

cap.13 EU65is 6500is 07.12.17 5:05 PM ページ13-2
b. DISASSEMBLY/REASSEMBLY
[2]
VALVE SPRING RETAINER (2)
DISASSEMBLY:
Push down and slide the retainer to the
side, so the valve stem slips through the
hole at the side of the retainer.
REASSEMBLY:
The exhaust valve retainer has a larger
center recess than the intake valve retainer,
so it can accept the valve rotator.
Do not remove the valve spring retainers
while the cylinder head is installed, or the
valves will drop into the cylinder.
[1]
VALVE ROTATOR
(Exhaust valve only)
REASSEMBLY:
If the valve rotator is not
installed, the exhaust valve
may drop into the cylinder
when starting the engine.
[17]
ROCKER ARM
PIVOT (2)
[16]
ROCKER ARM PIVOT
LOCK NUT (2)
10 N·m (1.0 kgf·m,
7 lbf·ft)
[15]
ROCKER ARM (2)
REASSEMBLY:
Before installing, check
for wear on the surfaces
which contact the pivot
bolt, push rod and the
rocker arm pivot.
13-2
[5]
VALVE GUIDE (2)
REPLACEMENT:
[4]
CLIP
(EX side only)
[3]
VALVE SPRING
SEAT (Exhaust
valve only)
[13]
PUSH ROD
GUIDE
[12]
VALVE SPRING (2)
INSPECTION: P. 13-3
[14]
ROCKER ARM
PIVOT BOLT (2)
24 N·m (2.4 kgf·m,18 lbf·ft)
[7]
EXHAUST VALVE
REASSEMBLY:
Do not interchange with the
intake valve.
INSPECTION: P. 13-4
P. 13-5
[6]
SPARK PLUG
INSPECTION: P. 3-5
[9]
CYLINDER HEAD
INSPECTION: P. 13-3
[10]
PUSH ROD (2)
REASSEMBLY:
Check both ends for wear and
check the rod for straightness.
Be sure the rod ends are firmly
seated in the lifters.
[11]
VALVE STEM SEAL
(Intake valve only)
[8]
INTAKE VALVE
REASSEMBLY:
Do not interchange
with the exhaust valve.
INSPECTION: P. 13-4