Honda EU65is Mode D'emploi page 352

cap.10 EU65is 6500is 07.12.17 4:56 PM ページ10-3
2. FRAME/UNDER PLATE/BOTTOM RUBBERS
a. DISASSEMBLY/REASSEMBLY
1) Remove the engine/generator assembly (P. 10-1 and 2).
2) Remove the stand and wheels (P. 16-3).
[2]
6 mm
FLANGE NUT
8.5 N . m (0.9 kgf . m,
6.3 lbf . ft)
[1]
GROUND CABLE
[13]
6 mm
LOCK WASHER
[12]
STOPPER
RUBBER (3)
[11]
BOTTOM RUBBER B
[10]
UNDER PLATE
10-3
[3]
[4]
10 mm
FRONT LEFT ENGINE BRACKET
FLANGE NUT (4)
34 N . m (3.5 kgf . m,
25 lbf . ft)
[5]
FRAME
[6]
BOTTOM RUBBER A (3)
REASSEMBLY:
Before installation, check
for cracks or deformation,
then install by aligning tab
with the hole in the frame.
[6]-1
TAB
[8]
WIRE HARNESS BAND (2)
6 x 16 (2)
[9]
OIL DRAIN HOLE COVER
[6]-2 HOLE
[7]
8 mm
FLANGE NUT (4)
24 N . m (2.4 kgf . m,
18 lbf . ft)