Carburetor - Honda EU65is Mode D'emploi

cap.04 EU65is 6500is (Eu).qxd 07.12.17 4:46 PM ページ4-4

3. CARBURETOR

a. REMOVAL/INSTALLATION
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Keep heat, sparks and flame away.
• Wipe up spills immediately.
• Handle fuel only outdoors.
1) Turn the fuel valve lever to the OFF position, and then
disconnect the fuel tube from the carburetor.
2) Remove the air cleaner (P. 4-2).
[4] HEAD COVER SHROUD
[3] 6 mm WASHER (2)
6 x 12 (2)
[2]
PLUG COVER
[1]
PLUG COVER BOLT
2.3 N . m (0.2 kgf . m,
1.7 Ibf . ft)
[17] 6 mm SPECIAL BOLT
8.5 N . m (0.9 kgf . m,
6.3 Ibf . ft)
[16]
INSULATOR GASKET
Do not reuse.
INSTALLATION: P. 4-5
[15]
CARBURETOR INSULATOR
INSTALLATION:
Install with vent
facing toward the carburetor.
[14]
CARBURETOR GASKET
Do not reuse.
INSTALLATION: P. 4-5
4-4
WARNING
groove
[13]
CARBURETOR ASSEMBLY
DISASSEMBLY/
REASSEMBLY: P. 4-6 and 7
[5] BREATHER TUBE
INSTALLATION:
Before
breather tube check for
deterioration or damage.
[6] MOTOR COVER (2)
INSTALLATION:
When installing the motor
cover, make sure the control
motor harness connector
remains connected securely.
[7]
To silencer
chamber
[8]
CONTROL MOTOR WIRE
(ENGINE WIRE HARNESS)
INSTALLATION:
[11]
[12]
CARBURETOR SPACER
AIR CLEANER GASKET
Do not reuse.
INSTALLATION: P. 4-5
installing the
P. 4-5
[9]
HARNESS CLIP
[10]
TUBE HOLDER
INSTALLATION: P. 4-5