Publicité
Les langues disponibles
Les langues disponibles
SAFETY
► Source of hazard: Environment in which the appliance is used
Hazard
Concentration
burnt gas emissions
due to an incorrect
installation
and/or
adjustment of the
gas system
Increase of work-
ing temperature of
components
Concentration
burnt gas emissions
due to an incorrect
installation
Concentration
unburned gas emis-
sions due to an in-
correct installation
Walls made of fl am-
mable material.
NOTE: Only applies to electrical appliances.
► Source of hazard: Electric power
Hazard
Risk of electric
shock caused by
live components
Risk of electric
shock caused by
live parts
3354462_ATG_ut_GB_rev.2
Where or in which situations
does the hazard occur?
of
In the event of inadequate
room ventilation; air and va-
pour extraction fault; incor-
rect installation, unsuitable
injector and/or primary air
regulation
In the event of inadequate
room ventilation; air and va-
pour extraction fault; incor-
rect installation, unsuitable
injector and/or primary air
regulation
of
In the event of inadequate
room ventilation; air intake
fault
of
• Incorrect installation
• Gas valve leak
• Incorrect installation
• Gas valve leak
Where or in which situations
does the hazard occur?
• Under protective panels
• Under the control panel
• Under protection covers
• On the appliance and on
the adjacent metal parts
• On the appliance and on the
adjacent metal accessories
Countermeasures
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance"
on page 9 of the installation
manual.
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance"
on page 9 of the installation
manual.
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance"
on page 9 of the installation
manual.
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance"
of the installation manual.
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance"
of the installation manual.
Countermeasures
• Operations to the electric sys-
tem may be carried out by
authorised and qualifi ed staff
only, in accordance with the
relevant applicable laws.
• Specialist procedure
• Comply with the correct instal-
lation requirements as per sec-
tion "Installing the appliance" of
the installation manual.
• Disable the power supply be-
fore removing the protections
• Prevent the appliance from be-
ing powered accidentally.
• Ensure that there is no voltage
• Before commissioning the ap-
pliance, check that all electric
connections are not damaged
• Use a power supply cable with
the specifi cations indicated in
section "Electrical connection"
of the installation manual.
• Before appliance commission-
ing, check that electrical con-
nections are securely fi xed
• Before commissioning, make
sure that the appliance and its
metal accessories are connect-
ed to a system for equipotential
bonding
ENGLISH
Safety
device
See
sec-
tion (safety
devices on
page 3)
See
sec-
tion (safety
devices on
page 3)
See
sec-
tion (safety
devices on
page 3)
See
sec-
tion (safety
devices on
page 3)
See
sec-
tion (safety
devices on
page 3)
Safety device
• Protection
panels
• System switch-
disconnector
Equipotential
bonding system
5
Publicité
