Angelo Po AT 61G Manuel D'utilisation page 278

ENGLISH
WARNING: Before carrying out any replacement procedure, activate all the safety devices
provided and decide whether staff at work and those in the vicinity should be informed.
In particular, turn off the gas and water supply taps, cut off the electricity supply to the appliance
using the master switch and prevent access to all devices which might cause unexpected health
and safety hazards if turned on.
WARNING: If worn parts have to be replaced, use original spare parts only.
WARNING: The manufacturer declines all responsibly for injury or damage to components
due to the use of non original parts, or extraordinary work on the appliance which may modify
the safety requirements without the manufacturer's authorisation.When ordering components,
follow the instructions provided in the parts catalogue.
WARNING: Replacement operations must be carried out by authorised, qualifi ed staff , in
accordance with the relevant legal requirements.
To carry out this operation, proceed as follows.
1) Undo the screws to remove the side panel (A).
2) Disconnect the gas supply line (B).
3) Remove the injector (C) and replace it with the one suitable for the type of gas in use (see table at
back of manual).
WARNING: Take care to ensure that the nozzle (C) is correctly positioned (see diagram).
4) Reconnect the pipe (B), replace the panel (A) and retighten the screws when the operation is com-
plete.
16
REPLACING PARTS
INSTRUCTIONS AND WARNINGS FOR REPLACING PARTS
REPLACEMENT OF THE BURNER NOZZLE
A
B
C
C
REPLACING PARTS
3354462_ATG_inst__GB_rev.2