Publicité
Table 1 — Dimensions of minimum zone of protection for back protector
NOTE All dimensions refer to the waist to shoulder length (100 %) of the biggest user.
Figure: Protector Types and their Respective Certified Protective Areas (Zones of Protection).
The certification of the Tech-Air
combination with the suit MISSILE V2 1PC LEATHER SUIT - 3150122 and RACING ABSO-
LUTE LEATHER SUIT – 3156319
WARNING!
Central Back Protector does not provide scapulae protection.
WARNING!
Lumbar Protector does not provide protection to the upper back.
WARNING!
Users should be aware that no Back Protector will provide complete
protection against spinal injury and no guarantees, warranties (ex-
press or implied) are made regarding the protector's ability to avoid
risk of spinal injury.
The protector integrated into the System is a Level 1 passive central Back Protector.
The following Table summarizes and explains the performance level reported on the product
marking as a passive impact protector:
Standard
Used for
Tested Area
tests method
applied in
tests
EN 1621-
Central Back
2:2014
56 EN
Dimensions in Figure 2
7x System – ABS7XI24 System has been conducted in
®
Force Trans-
mitted with
Impact Energy
Temperature
of 50 Joule
Value Aver-
age/ Maximum
Average ≤ 18kN
23°C
Peak ≤ 24kN
Level
Level 1 requirements:
average value
18kN; No
≤
impact above 24kN
Level 2 requirements:
average value
9kN; No
≤
impacts above 12kN
Level 1
Publicité
