Publicité
9. System Installation and Fitting
The System can be used as a Standalone System or as an Integrated System within a com-
patible suit or jacket. The two installation modes are described below.
Standalone System Installation
To use the System as a Standalone System with an Outer Garment, the User must go
through the following steps:
1. Put on the System with the Converter (4) attached to the front.
2. Close the Front Flap (3) taking care to correctly attach the hook-and-loop by lining up the
patches, as shown in Figure 11; the System automatically turns on as soon as the Front Flap
(3) is attached to the hook-and-loop patch.
3. Once the Front Flap (3) has been correctly closed, check the LED Display (2) to verify
that the System has turned on and that it has started correctly (see Section 13 "Display
Indications"). In particular, the User must verify that after the System starts-up, there is no
System Fault present.
Figure 11: How to switch on the System;
4. Upon successful System start up, as indicated by the solid green LED (2c), the User can
now close the central zip present on the Converter (3) and proceed to put on the Outer Gar-
ment taking care that the System remains well fitted underneath the Outer Garment, and
that all fits perfectly in place. Be sure to pay particular attention to ensure that the shoulder
areas of the System are correctly positioned within the sleeves of the Outer Garment.
23 EN
Publicité
