Publicité
18. Troubleshooting
Problem
LED Display (2) does not
switch on when Front
Flap (3) is closed
Solid red LED (2a) on the LED
Display (2)
Blinking red LED (2a), while
green LED (2c) is on
48 EN
Possible Cause
Battery (14) fully discharged
Front Flap (3) is not correctly
positioned on the hook-and-loop
patch
Gas Inflators (15) empty and/or
Airbag must be replaced
System Error
Battery Low
Possible Solutions
Recharge Battery (14) (Section 11) and check
the correct LED behavior during the recharge.
Check the correct alignment between Front
Flap (3) and hook-and-loop patch.
After a second deployment, the Gas Inflators
(15) must be replaced. The System will not
work even though the Battery (14) is charged
and the LED Display (2) will show the solid
red LED (2a) until the Gas Inflators (15) are
replaced.
If the number of available Airbag inflations
is 0, the solid red LED (2a) will report the
System Fault even after the Gas Inflators (15)
replacement. In this case, the Airbag itself
must be replaced and the System reactivated
by the authorized dealer where the System
was purchased.
The System has an error. Contact the author-
ized dealer where the System was purchased.
Remaining battery level is lower than 4 hours.
Recharge the Battery (14) as soon as possible.
Publicité
