Publicité
5. Once the System has been correctly positioned on the body, close the Outer Garment.
Integrated System Installation
To use the System as an Integrated System with an Outer Garment, the User must go
through the following steps:
1. System Preparation. Remove the Converter (3) and make sure that all the Velcro attach-
ments present on the Base Layer (1) do not have their protective covers attached. There are
5 Velcro attachments (Figure 12): 4 placed on the shoulder areas and 1 positioned on the
neck area. If the protective Outer Garment is equipped with a compatible Tech-Air
Display integrated inside the sleeve, it is possible to connect the System to the external LED
Display using the External LED Display Connector (17) located underneath the Back-Protec-
tor (5) cover through the opening shown in Figure12.
Figure 12: Velcro Attachments and External LED Display Connector (17) Locations
2. System Installation. Remove the inner liner from the protective Outer Garment. If pres-
ent, first connect the integrated LED Display using the External LED Display Connector (17).
Then proceed placing the System inside the Outer Garment, making sure to position all
the Velcro attachments correctly. Finally, connect the zippers of the System to the zippers
present on the Outer Garment. Proceed by inserting the inner liner, passing it internally to
the sleeves, and make sure the Front Flap (3) is exposed to allow the System to turn on once
the Outer Garment is on.
24 EN
External LED Cable
Connector (17)
LED
®
Publicité
