Publicité
14.2.1 Removal of Non-Washable Parts
The first step that the User MUST follow is the removal of non-washable parts, which in-
clude: Airbag, Gas Inflators (15) and ALL the electronic components, including the LED Dis-
play (2) and the wiring. This operation can be done following these indications:
1. Detach the Airbag. Access the Airbag through the Internal Openings (7) shown in Figure
6 and proceed to open all the connection clips arranged as shown in Figure 14. Each clip
has a color and number to assist the User in proper assembly. The System has a total of 11
Connection Clips: 2 clips on the left shoulder area (#2 blue - #2 red), 2 clips on the right
shoulder area (#2 blue - #2 red) area, 3 clips on the left side of the chest area (#3 red – #4
green - #5 blue), 3 clips on the right side of the chest area (#3 red – #4 green - #5 blue) and
3 clips for the back area (#1 green – # blue – # red). It is suggested that the User detach the
clips beginning with the clips located on the back area, then detach the clips on the chest
area and, finally, detach the clips on the shoulder area (see Figure 14).
CHEST
CHEST
LEFT
RIGHT
SHOULDER
SHOULDER
LED WIRING ELASTIC
BASE LAYER OPENINGS
LOOP LOCATION
Figure 14: Connection clip locations on the Airbag (left) and on the System's Base Layer (1) (right)
32 EN
Publicité
