Publicité
garment, that the protectors are correctly positioned. If the garment you have chosen is a
leather garment, it is highly recommended that it has stretch panels to accommodate the
inflated Airbag after deployment.
The System's Airbag covers the shoulder, chest, and full back area, accordingly, the System
must not be used inside of a leather suit or a 2-piece leather suit, unless such leather suit
or 2-piece leather suit has sufficient space to accommodate the inflation of the Airbag, as
shown below, and it's not too tight in the crotch area, in order to prevent discomfort in the
event of deployment.
Moreover, it is highly recommended to use the System in combination with a protective gar-
ment, therefore certified in accordance with EN 17092 Parts 2, 3, 4 or 5, that can guarantee
protection for the uncovered areas of the System.
IMPORTANT!
When the System is used with an Outer Garment, other than those specifi-
cally designed by Alpinestars for Tech-Air
the Outer Garment provides enough inner volume able to accommodate the
deployed Airbag as follows:
1. For the chest area, measure the circumference of the chest (A) and the garment width on
the chest region (A1). The garment is compatible with Tech-Air
14 cm (A1 > 0.5 x A + 5.51 in)
2. For the Shoulders area (B), be sure that the suit can be raised up 4 cm without creating
any discomfort.
A
Body measure
22 EN
B
B
A1
Garment measure
Systems, the User must verify if
®
7x System if A1 > 0.5 x A +
®
WARNING!
The System must ALWAYS be used with
a correctly fitting Outer Garment of the
User's appropriate body size. Use of the
System with the incorrect size of an
Outer Garment, or not compliant with
the size check recommendations above,
may result in the System malfunction or
failure and injury, including severe injury
and/or death.
Publicité
