Optional Xprt™ Therapy Mattress; Optional Positionpro™ Patient Repositioning Mattress Option - Stryker InTouch FL27 Manuel D'utilisation

OPTIONAL XPRT™ THERAPY MATTRESS
If your bed is equipped with the XPRT™ Therapy Mattress option, perform the following setup procedures to install
the Mattress . For graphic representation of the setup procedures, refer to the XPRT™ Therapy Mattress Operations
Manual .
1 . Place mattress over bed litter with printed logo at head end of the bed .
2 . Fold back foot end section of mattress .
3 . Place foot box on foot end of bed litter .
4 . Connect the two (2) color coded connectors on the foot box to the corresponding color coded connectors on the
mattress . Connect black connection on foot box to cable adapter 2950-001-180 and then to the bed frame .
5 . Turn the locking collars clockwise to secure the connections .
6 . Connect the other end of the black connector to the bed (left side of litter at foot end behind the accessory outlet) .
7 . Connect the air line from the mattress to the corresponding fitting on the foot box .
8 . Fasten the two (2) retaining clips to the two (2) D-Rings on the foot box .
9 . Lower the foot section of mattress over the foot box . Attach the mattress to the bed frame using the mattress
tie-downs .
10 . Apply linens utilizing the "D" rings for the flat sheet .
11 . To secure linens, to mattress, thread four corners through D-Rings attached to mattress .
12 . To ensure proper therapy, do not pull linens taut . The linens should remain loose and wrinkly on the surface of
the mattress .
13 . Plug the mattress power cord into a properly grounded, hospital grade receptacle .
Note
The InTouch® bed will detect when the mattress has been connected as well as what type of mattress it is . This will
be shown on the InTouch® screen .
WARNING
• Do not route the power cord between the mattress and the bed frame .
• Do not attach the power cord to any moving parts of the bed frame .
• The power cord could be pinched and may cause electrical shock if a bed extender is used .
OPTIONAL POSITIONPRO™ PATIENT REPOSITIONING MATTRESS OPTION
If your bed is equipped with the PositionPRO™ Patient Repositioning Mattress option, perform the following setup
procedures to install the mattress . For graphic representation of the setup procedures, refer to the PositionPRO™
Mattress Operations Manual .
1 . Place the mattress onto the bed .
2 . Flip the foot section towards the head end .
3 . Place the control box (upside down) into the opening in the foot section .
4 . Connect outer transparent tubes to manifold, matching the color coding .
5 . Connect tilt sensor cables .
a . Align the white dots .
b . Twist clockwise to fasten .
6 . Connect pendant cable .
7 . Connect power cord (4') and turn the switch to on .
Note: The switch is hidden under the power cord .
8 . Fasten straps over the power cord .
9 . Install the power cord in the two (2) retaining clips .
10 . Fasten the three (3) retaining straps .
11 . Carefully rotate the foot end control box and the mattress into the flat position .
Return To Table of Contents
1-16
Setup Procedures
2151-009-005 REV B www.stryker.com