Stryker InTouch FL27 Manuel D'utilisation page 61

The Optional Bed Extender was designed to lengthen the bed by six inches .
This accessory is designed for the following product(s):
• InTouch® 2 .5 (FL27)-2151/2152
• InTouch® 2 .5 (FL27)-2153/2154 with PositionPRO™
• InTouch® 2 .5 (FL27)-2155/2156 with XPRT™
INSTALLATION
Required Tools: None
Refer to the figures following the Installation section for visual help .
1 . Install the appropriate mattress cushion over
the bed extender (see Figure A) .
2 . Remove the footboard .
3 . Insert bed extender legs on the bed end rods (see Figure B) .
4 . Replace the footboard over the bed extender rods (see Figure B,
section 2) .
WARNING
• Ensure connector 'A' is securely fixed (see Figure B) .
• Do not sit on the bed extender . This may cause the bed to flip .
Connector A
www.stryker.com
Bed Extender - FA64234-XXX
Figure B
2151-009-005 REV B
Figure A
Section 2
Section 1
Return To Table of Contents
1-59