Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SCALE SYSTEM CONTROL PANEL GUIDE (OPTIONAL)
WARNING
The weight system (optional) is intended to assist in the monitoring of the patient's weight variation . Under no circumstances
should its readings be used as sole reference for medical treatment .
Note
When the bed is powered on, the scale display will show a welcome message and the version (X .X) of the control
software:
I:
/ Enter Control
• Press
once to activate the display . The Scale mode will be displayed .
• The display may be shut off by pressing the
• Press ENTER when instructed to do so .
J:
Zero Control
• To zero the scale
H:
Menu Up/Down Controls
• Press either control repeatedly until desired mode is reached .
G:
Scale Display
Scale Menu Modes
Order of appearance of the modes when the MENU Down control is pressed repeatedly:
Mode
Scale
Gain or Loss
Gain or Loss Reference Weight
Change Equipment
Change Patient Weight
Select Weight Unit (lb/kg)
Note
• The scale readings must be within the range specified in the Specifications section of this manual . Otherwise, the
scale must be calibrated . Refer to the scale calibration procedure of the Maintenance Manual .
• The scale does not operate when the bed is inclined more than 12° in the Trendelenburg or reverse Trendelenburg
position . The LCD will display a warning message and the current bed angle, but not the patient's weight .
• Should the message "No Scale Found" appear on the screen during the normal course of operation of the scale,
press the enter key . Data will reappear on the screen and the current operation will resume . If the message
remains, contact Technical Support .
www.stryker.com
Operation Guide
G
H
Figure 2.14B
S
T
R
Y
K
S
C
A
L
E
key .
First Line Appearing
Weight Angle
Gain Or Loss
Gain/loss Zero
Change Equipment
Change Patient Weight
Units
280C-009-001 REV B
I
J
E
R
V
X
.
X
Return To Table of Contents
1-19
Publicité
Chapitres
Table des Matières
