11 Diagnostics Menu - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus

11 Diagnostics menu

Main menu
IO Setup
Limit
Timer
Autoaddressing
Diagnostic
000419:27:28
Runtime Controller
000146:23:54
Runtime Motor
585 V
DC-Voltage
400 V
Line voltage
28.1 °C
IGBT temp.
29.5 °C
Elcap. Temp.
30.1 °C
Sinefilter
20.0 °C
E1 - KTY
9.0 mA
E1-Current
4.0 V
E1 - Voltage
20.0 °C
E2 - KTY
L-BAL-E304-GB 2004
The diagnostics menu supplies information about the momentary operating condition
of the device.
Operating hours on the line
The time counter (h:m:s) runs as soon as line voltage is applied to the device and the
device is switched on (without failure).
If events step on (Motor fault, External Error, etc.), the period of operation is stored at
this time ( Protocol).
Operating hours with modulation
The time counting (h:m:s) runs only when a modulation of the controller is present
DC-Voltage
The intermediate circuit voltage without load is the peak value of the input voltage.
In a three-phase supply network with 400 V, an intermediate circuit voltage of ca. 565 V
results. This voltage sinks slightly under load.
Line voltage
IGBT temp.
Display of the internal temperature of the power semiconductor. At impermissibly high
temperatures (from 90 °C), the output power is automatically reduced. The device is
switched off at 105 °C.
Elcap. Temp.
Display of temperature of electrolytic capacitors.
At impermissibly high temperatures, the output power is reduced or the device switched
off.
Sinefilter
Display of sine filter choke temperature. In case of temperature increase above prede-
termined threshold value the modulation is switched off. Restart when cooled down!
(only in version with integrated sine filter)
E1
Signal height at analog input E1 (Analog In 1)
E2
Signal height at analog input E2 (Analog In 2)
Part.-No.
113/139
Diagnostics menu