Helios FU Comfort Sinus Manuel De Montage Et D'utilisation page 205

Installation and Operating Specification FU Comfort Sinus
Setting of the desired function
Function
OFF
Constant voltage 10 V
(1A)
1. Control signal
(2A)
E1
(3A)
E2
(4A)
Group2
(5A)
2.Cooling
(6A)
2.Heating
(7A)
2. control signal
(8A)
Output frequency
(9A)
Group3
(11A)
Group4
(12A)
Offset control sig. 1
(14A)
Factory assignments: Virtual outputs / actual outputs
Virtual output
AO1
AO2
AO3
AO4
AO5
AO6
L-BAL-E304-GB 2004
Designation
no function
Constant voltage +10 V (factory setting)
Proportional to the internal activation of the power unit (control circuit 1) under consid-
eration of "Min. Speedl" and "Max. Speed".
•
"OFF"
for enable it goes back to 0 V
•
for motor fault the output signal remains for a slave controller (
combination).
proportional input "E1"
proportional input "E2"
Group control (see controller setup group 2)
2.03
Only for mode temperature controller with additional functions.
Controller output 2 with rising activation at Actual>Nominal = Cool.
2.03
Only for mode temperature controller with additional functions.
Controller output 2 with rising activation at Actual<Nominal = Heat.
Controlled 0 - 10 V output for control circuit 2 (factory setting for "A1" at operation
with second control circuit).
Control circuit 2 can be activated by programming the E2 function if required (see Base
setup / Operation with second control circuit).
Proportional to the output frequency
Group control (see controller setup group 3)
Group control (see controller setup group 4)
Offset control signal 1
Offset setting (see controller setup)
Actual output
A1
Signal
Check signal
n.a.
n.a.
n.a.
n.a.
Part.-No.
66/139
Explanation
analog output "A"
Funktion zugeordnet jedoch kein Ausgang vorhanden
not available
(no output assigned)
not available
(no output assigned)
not available
(no output assigned)
not available
(no output assigned)
Programming
"Master-Slave"