Outdoor Installation; Installation Location For Agriculture; Temperature Influences During Commissioning - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
Housing with aluminum base plate
1 Cable inlet with step nozzles (factory installed)
1A 3 x max. 18 mm
1B 3 x max. 14 mm
1C 3 x max. 11 mm
1D 4 / 8 x max. 8 mm
2 attached cable inlet for cable glands
2A 17 / 21 mm
2B 12.5 / 17 mm
3 Fastening screws
Sheet metal housing
IP54
1 Inlet mains connection (40 mm)
2 Inlet motor connection (40 mm)
3 Inlet control cables (20 mm)
Information
•
Cable glands can be used alternatively (not included in delivery). The manufacturer's specifications
for tightening torque and sealing area must be observed!
•
Openings which are not needed must be sealed!
4.5

Outdoor installation

Outdoor installation is possible up to -20 °C when the controller supply is not switched off. Installation
must be protected from the effects of weather as much as possible, including protection from direct
sunlight!
4.6

Installation location for agriculture

When using for animal keeping, do not install the device directly in the stable but in a separate room
with a lower pollutant load. This helps to avoid damages caused by pollutant gases (e.g. ammonia
fumes, hydrogen sulphide fumes).
4.7 Temperature influences during commissioning
Avoid condensation in the controller and functional faults attributable to condensation by storing the
controller at room temperature!
L-BAL-E304-GB 2004 Part.-No.
13/139
Mounting