Menu Group Info - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
OFF
US Einheiten
Start
OFF
Reset
Start
1.01
Mode
Start
12.19
FU-XX
Start
SN: 154036311039
9.7

Menu group Info

The first menu item in the Info menu group is displayed (display dependent on selected mode) after switching on
the line voltage or after exiting the setting menu with the Esc key combination.
Settings cannot be made in this menu group!
Info
0.0 Hz
Frequency
Info
0.0 A
Motor current
Info
0 %
Modulation
Info
17.5 Hz
Set external1
L-BAL-E304-GB 2004
US Einheiten
The display can be switched between SI units and imperial (US) units =>US units ON.
SI units (factory setting): °C, bar, Pa, m
Imperial (US) units: °F , psi, in.wg, cfm, K-Faktor US, ft/s
Settings for temperature differences (with SI units in K) are also made for Imperial units
(US) in °F (Δ 1.8 °F
Δ 1 K).
Conversion factors:
•
Temperature: t / °F = 1,8 x t °C + 32.
•
Pressure: 1.0 psi = 0.069 bar, 1.0 in.wg = 254 Pa
•
Air flow: 1.0 cfm = 0.5885 m
•
Speed: 1.0 ft/s = 0.3048 m/s
In order to refresh the display, the desired mode must be confirmed again after switch-
ing over the units ( Base setup)!
Reset
Complete re-start of the device
Mode
Query of the operating mode (e.g.
Device name
Display of device name and software version
Individual unit number
Info for mode speed controller
Inverter output frequency.
Display of motor current (Metering precision approx. +/-10 %)
Display 0...100 % 0...Max. Frequency (see Motor Setup)
Display of the currently active setting under consideration of the settings "Min. speed"
and "Max. speed".
Display:
"Set external1"
"Set external2"
"Set Internal1"
"Set Internal2"
Part.-No.
49/139
3
/h, K-Factor, m/s
3
/h, inlet ring: K-Factor US = 9.3 x K-Factor SI
1.01
for speed controller)
1.01
The device operates at:
Signal to "E1" / "GND"
Signal to "E2" / "GND"
Menu "Set Intern1"
Menu "Set Intern2"
Programming