Function Of The Timer - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
9.12.1

Function of the timer

If necessary the clock module type Z-Modul-RTC Part.-No. 380056 can be retrofitted. On the PCB
board is the plug connection
The device has then a real-time clock. The clock is buffered and has after sufficient length of time with
voltage supply a 2 - 3 day reserve.
The time and date must be set during start-up operation and when using the real-time clock. The
device calculates the weekday based on the date.
In principle, the timer function acts like a digital switch input (timer "On"
OFF). The same functions can be assigned to the timer switch as the digital inputs (see IO Setup/Di-
gital inputs "DI").
Inverting of the timer function
The timer function can be inverted by inverting the digital input to which the timer function is assigned
(see IO Setup/Digital inputs "DI").
With inversion "DI" = "OFF" (factory setting) the programmed function is activated at the switch on time
(clock symbol in display) and deactivated again at the switch off time.
With the setting "DI" ="ON" the programmed function is deactivated at the switch on time and
reactivated at the switch off time (clock symbol in display).
Function
OFF
Enable
(1D)
External error
(2D)
Limit
(3D)
E1 / E2
(4D)
Reset
(10D)
Max. Speed
(11D)
Motorheating
(12D)
Switch over direction
of rotation
(13D)
Freeze function
14D
Override Time
(21D)
Setpoint1/2
(5D)
Setpoint int./ext.
(6D)
In modes from
Setpoint1/2
(5D)
Setpoint int./ext.
(6D)
L-BAL-E304-GB 2004
| |
X13 available.
Description *
no function (factory setting)
Enable (remote control) "ON" / "OFF"
External fault alarm
"Limit" ON / OFF
Influences control circuit 1 and control circuit 2 in operation
with two control circuits
Switch over input "E1" / "E2" (for operation with one control
circuit)
Complete re-start of the device
Setting Max. Speed "ON" / "OFF"
Influences the respectively set value "1. Max. Speed" and "2.
Max. Speed" in operation with two control circuits.
Motorheating ON / OFF
Reverse direction of rotation "right-hand" / "left-hand" (only for
frequency inverter with 3 ~ output)
"Freeze function" = maintain momentary modulation value
Do not use function for timer (only for digital input).
Switch over "Set Intern1" / "Set Intern2"
"Setting External 1" must be at "OFF"
Switch over "Intern" / "Extern"
2.01
Switch over "Setpoint 1" / "Setpoint 2"for control circuit1
Switch over "Intern" / "Extern"
Possible only for operation with one control circuit!
In mode 1.01
Part.-No.
95/139
Programming
closed contact at inverting
Timer ON =
(@ Timer Invert. = OFF)
Device ON
Fault
Limit ON
Signal at E2
Reset
Max. Speed ON
Motorheating ON
Switch over direction of
rotation
Modulation is retained
-
Set Internal2
Set external
Set Internal2
Setpoint External