Switch Over Input Signal "E1" / "E2", Function; Set 1/2 Or Setpoint 1/2, Function - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
9.9.6.4

Switch over Input signal "E1" / "E2", Function

Switch over between Input signal 1 (Analog In 1 terminal "E1") and input signal 2 (Analog In 2 terminal
"E2").
Contact e.g. at ditgital input "Digital In 1" (depending on device type at terminals "D1" - "D1"or "D1" -
"24 V").
Si 1 Signal 1
Si 2 Signal 2
For mode speed controller (
For modes controller (higher
otherwise does not occupy).
9.9.6.5

Set 1/2 or Setpoint 1/2, Function

For Mode Speed controller
Contact e.g. at ditgital input "Digital In 1" (depending on device type at terminals "D1" - "D1"or "D1" -
"24 V").
2
- - - - -
1
- - - - -
1 Setting "Set Intern1" (depending on device type in: %, Hz, rpm)
2 Setting "Set Intern2" (depending on device type in: %, Hz, rpm)
Info
50 %
Modulation
For operation as controller (starting from
For operation with second control circuit: switch over "1.Setpoint 1" / "1.Setpoint 2"
Contact e.g. at ditgital input "Digital In 1" (depending on device type at terminals "D1" - "D1"or "D1" -
"24 V").
L-BAL-E304-GB 2004
Controller
E1
Si 1
GND
E2
Si 2
24V
GND
D1 D1
0 1
1.01 ) Base setup for "E2 Analog In":
2.01 ..) Base setup for "E2 Analog In":
| |
5D
1.01 : Switch over "Set Intern1" / "Set Intern2 "
Controller
1 n = 40 %
n = 80 %
0
24V
D1 D1
v_5d_vorgabe_intern_1_2.vsd
0 1
Operation with "Set Intern2" is signalized by the moon symbol for reduced operation.
"Set extern1" under "settings" must be programmed to "OFF".
2.01
Part.-No.
78/139
| |
4D
0
Si 1
Si 2
1
n = 0- 100 %
26.05.2010
v_4d_umschaltung_e1_e2.vsd
| |
1E necessary.
| |
7E
•
"D1 Inverting"
opened contact /
contact.
•
"D1 Inverting"
closed contact /
contact.
11.05.2007
): switch over "Setpoint 1" / "Setpoint 2"
Programming
necessary (as far as
"OFF" "Set Intern1"
= : at
"Set Intern2"
at closed
"ON" "Set Intern1"
= : at
"Set Intern2"
at opened