Air Velocity Control; Base Setup 6.01 - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
9.4

Air velocity control

9.4.1 Base setup
Main menu
Start
Setting
Protocol
Base setup
Controller Setup
Base setup
6.01
Mode
Base setup
MAL10
E1 Analog In
Base setup
0.00 m/s
E1 Offset
Base setup
OFF
E2 Function
L-BAL-E304-GB 2004
6.01
6.01
Base setup
Mode
Mode selection
E1 Analog In
The sensor input is factory set for mode
Measuring range: 0...10 m/s
Output signal: 0 - 10 V
Connection terminals: "E1", "GND", "24V"
Other settable sensors / measuring ranges:
•
MAL1 (0...1 m/s, output signal 0 - 10 V)
•
MAL10 (0...10 m/s, output signal 0 - 10 V)
•
MAL15 * (0...15 m/s, output signal 0 - 10 V)
•
MAL20 * (0...20 m/s, output signal 0 - 10 V)
•
0 - 10 V, 0 - 20 mA, 4 - 20 mA (for sensors with free measuring range and linear
characteristic)
The sensor measuring range must be entered for sensors with free measuring range in
order to display the actual value correctly.
Example 0 - 10 V sensor and measuring range 0 - 5 M/s:
E1 Analog In = 0 - 10 V, E1 Unit = m/s, E1 Decimals = 1, E1 Min. = 0,0 m/s, E1 Max. =
5 m/s
* Alternative measuring ranges which can be selected by jumpers for sensor type
MAL10.
E1 Offset
Sensor calibration with calibrated comparison device.
The current "E1 Actual" is displayed including the offset set here.
"E2 Function"
Adjustable
• | |
1E
= External setpoint e.g. by external signal (0 - 10 V) instead of setting
"Setpoint 1"
• | |
2E
= External manual operation via external signal (0 - 10 V). Switching between
setting on the device and external manual operation via digital input (
|
7D
Function
• | |
3E
= Sensor average to E1
• | |
4E
= Sensor comparison to E1
• | |
5E
= Sensor difference to E1
• | |
6E
= sensor for outdoor temperature-dependent setpoint adaptation, pre-pro-
grammed sensor type
– Menu group
– Menu group
– Example
• | |
7E
= Measurement value = Measurement value e.g. for limit indication, display in
"E2 Actual"
Info menu
• | | |
8E 13E
...
with second control circuit.
6.01
6.01
. 0 - 10 V 0 - 100 % sensor measuring range.
|
).
"TF.."
.
"Setting"
additional parameter: T-Band, T-Start SA, Min. Setpoint.
"Info"
additional parameter: Setpoint control
4.01
Setting for operation
.
|
= sensor input for control circuit 2
Part.-No.
44/139
Programming
to sensor type "MAL10 ".
4.02
... / additional menu items.
base setup / operation
IO Setup: