Helios FU Comfort Sinus Manuel De Montage Et D'utilisation page 215

Installation and Operating Specification FU Comfort Sinus
Setpoint int./ext.
(6D)
Setpoint1/2
(5D)
Setpoint int./ext.
(6D)
Control/Manual
(7D)
Heating/Cooling
(8D)
E1 / E2
(4D)
2. Setpoint 1/2
(9D)
1.Setp+Pband1/2
(15D)
2.Setp+Pband1/2
(16D)
Factory assignments: Virtual inputs / actual inputs
Virtual input
Inverting
DI1
OFF
Inverting
L-BAL-E304-GB 2004
Switch over "Intern" / "Extern"
For modes as controller (from
Switch over "Setpoint 1" / "Setpoint 2"for control circuit1
Switch over "Intern" / "Extern"
Possible only for operation with one control circuit!
Switch over "automatic control" / "Speed manual"
Possible only for operation with one control circuit!
Switch over control function (e.g. "heating" / "cooling")
Only active in operation with a second control circuit
The output for control circuit 2 is set additionally to "A2" to "A1" (regardless of the
programmed function for "A1"). Control circuit 1 has no output for the duration of the
switching.
The switch over input "E1" / "E2" as in operation with one control circuit is no longer
possible.
for control circuit 2: Switch over "2. Setpoint 1" / "2. Setpoint 2"
for control circuit 1: Switch over Setpoint 1/2 and Pband 1/1
When programming this function, "Setting" additionally lists the parameter: "1.Pband 1.
for control circuit 1"
for control circuit 2: Switch over Setpoint 1/2 and Pband 1/2
When programming this function, "Setting" additionally lists the parameter: "2.Pband 2
for control circuit 2"
Real input
DI1
DI2
DI3
DI4
DI5
DI6
Inverting
The inverting of digital inputs is factory set to "OFF" (if a function is programmed).
To invert the function, switch to "ON" (display
for DI1).
Explanation
D1
D1 FU-C(S)
Signal
D2
D2 FU-C(S)
Signal
not available
n.a.
(no input assigned)
not available
n.a.
(no input assigned)
not available
n.a.
(no input assigned)
not available
n.a.
(no input assigned)
Part.-No.
76/139
2.01. )
| |
- - - - as long as no function is allocated
Programming