Limits; Limit Indication Depending On Modulation - Helios FU Comfort Sinus Manuel De Montage Et D'utilisation

Installation and Operating Specification FU Comfort Sinus
Example: speed limitation over Timer (Function
The timer limits the maximum speed for a certain period of time (e.g. timer ON from 6:00 - 10:00 am).
With the "Override Timer" contact the limitation (from 6:00 - 10:00 am) activated by the timer can be
cancelled for an adjustable period "Override Time" (see timer / timer function overwritten: Override
Status = OFF)
To activate the limitation outside the programmed time (10:01 - 5:59 am) => "Override Status" = ON
9.10

Limits

Main menu
Protocol
Base setup
Controller Setup
IO Setup
Limit
9.10.1

Limit indication depending on modulation

only for Modulation control circuit 1!
Display for operation with two control circuits: 1.Modul. function, 1.Modulation min., 1.Modulation
max., 1.Modul. Delay
Limit
OFF
Controller function
Limit
30 %
Level min.
Limit
40 %
Level max.
Limit
2 sec
Level Delay
|
* Display - - - -
L-BAL-E304-GB 2004
Limit
Following functions can be allocated to the limit indication
OFF
Fault
(1L)
Message
(2L)
Filter error
(3L)
Filter Message
(4L)
In the IO setup, a separate relay can be allocated independent of these settings.
If the modulation exceeds the set "Modulation max" value, this is reported until the set
value "Modulation min" has been undercut.
The indication is delayed by the time set in "Display delay".
Setting range: 0 - 100 %
Factory setting: 30 % / 40 % *
Time delay exceeding "Modulation max." up to indication by relay and alarm symbol.
Setting range: 0 - 120 sec.
Factory setting: 2 sec. *
|
as long as function = OFF
| |
3D )
no function (factory setting)
Limit alarm alternating with actual value display Is listed in the
protocol as an alarm.
Indication with the centralized fault of a programmed relay (IO
| |
allocation Function 2K ).
Is listed in the protocol as a message. There is no alternating
message on the actual value display and no message via alarm
relay.
| |
with fault message "Filter"
Like function 1L
| |
Like function 2L with fault message "Filter"
Part.-No.
83/139
Programming