Helios FU Comfort Sinus Manuel De Montage Et D'utilisation page 212

Installation and Operating Specification FU Comfort Sinus
Function
1K
2K
3K
4K
5K
6K
7K
Factory assignments: Virtual outputs / actual outputs
Virtual output
DO1
DO2
DO3
DO4
DO5
DO6
Inverting
DO1
OFF
Inverting
L-BAL-E304-GB 2004
Controller status
Operation without fault, line supply okay
Fault with indication by relay
External Fault at digital input for external fault
Exceeding or falling below modulation
over or falling below limits for input signal "E1"
over or falling below limits for input signal "E2"
setpoint deviation to high
Actual output
Signal
Signal
Inverting
The inversion of the relays "K1" and "K2" is set at the factory to "OFF" (when a function
is programmed).
For switching inversion to "ON" (switching behaviour dependent on assigned function).
The relays can only pull up basically when the voltage supply of the electronics is
working. Three-phase current devices must have at least 2 line phases!
Explanation
K1
K1 FU-CS
K2
K2 FU-CS
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
not available
n.a.
(no output assigned)
Part.-No.
73/139
Programming
K1/ K2
1 = energized
0 = de-energized
Inverting
OFF
ON
1
0
0 1
1
0
1 0
1
0
1 0
1
0