Installation and Operating Specification FU Comfort Sinus
9.6
Menu group Start
Main menu
Start
Settings
Protocol
Base setup
Controller Setup
Start
OFF
Motor
Start
- - - - -
PIN input
Start
D
Sprache
L-BAL-E304-GB 2004
Start
Motor
In this menu point the modulation for the motor can be switched on and off (ON / OFF).
|
|
Factory setting to
OFF
, this prevents the system from inadvertently starting up before
configuration is complete.
When operating with two control circuits, the switch-off affects both outputs, i.e. the
inverter output of control circuit 1 and the signal output 0 - 10 V of control circuit 2 .
Attention!
The ON/OFF key affects the following function see Multifunction - LC display and
keyboard!
No disconnection (isolation) when switched off, in accordance with VBG4 §6)!
PIN input
The service menu for the installation can be protected against unintentional changes
by a pin code. With further pin codes putting back to pre-setting is possible.
PIN 0010
Opening service menu, if PIN-protection activated.
PIN 1020
Reactivate wizard for first-time start-up
PIN 1234
Freischalten Menu group "Setting".
If "Set protection" = "ON" (see Controller Setup)
PIN 9090
Restore user setting.
PIN 9091
Save user setting (corresponds function "Save user setup" = "ON" see Controller
Setup)
PIN 9095
Restore factory setting = delivery status
Exception:
The stored events in the "Protocol" menu are retained after resetting to factory setting!
Language
In this menu different national languages can be selected (GB = English, D = German
...).
Part.-No.
48/139
Programming