Publicité
FRONT FORK
4. After filling, pump the damper assembly 1
slowly up and down (about 200 mm (7.9 in)
stroke) several times to bleed the damper
assembly of air.
NOTE:
Be careful not to excessive full stroke. A
stroke of 200 mm (7.9 in) or more will cause
air to enter. In this case, repeat the steps 2 to
4.
5. Inspect:
9 Oil amount
While keeping the damper assembly fully
stretched, check that the oil is above the
step a on the damper assembly.
Below the step¡Replenish fork oil above
the step.
6. Tighten:
9Locknut 1
NOTE:
Fully finger tighten the locknut onto the
damper assembly.
7. Loosen:
9 Compression damping adjuster 1
NOTE:
9 Loosen the compression damping adjuster fin-
ger tight.
9 Record the set position of the adjuster (the
amount of turning out the fully turned in posi-
tion).
8. Install:
9 Base valve 1
To damper assembly 2.
NOTE:
First bring the damper rod pressure to a maxi-
mum. Then install the base valve while releas-
ing the damper rod pressure.
5-33
CHAS
Publicité
