Yamaha WR250F Manuel D'atelier page 582

All manuals and user guides at all-guides.com
5 - 58
SWINGARM
5. Install:
Relay arm 1
Bolt (relay arm) 2
Washer 3
Nut (relay arm) 4
To swingarm.
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Do not tighten the nut yet.
6. Install:
Swingarm 1
Pivot shaft 2
85 Nm (8.5 m · kg, 61 ft · lb)
NOTE:
Apply the molybdenum disulfide grease on
the pivot shaft.
Insert the pivot shaft from right side.
7. Check:
Swingarm side play a
Free play exists → Replace thrust bear-
ing.
Swingarm up and down movement b
Unsmooth movement/binding/rough
spots → Grease or replace bearings,
bushings and collars.
8. Install:
Bolt (connecting rod) 1
Washer 2
Nut (connecting rod) 3
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Do not tighten the nut yet.
9. Install:
Washer 1
Bolt (rear shock absorber-relay arm) 2
53 Nm (5.3 m · kg, 38 ft · lb)
NOTE:
Apply the molybdenum disulfide grease on
the bolt.
Insert the bolt from right side.
CHAS