Yamaha WR250F Manuel D'atelier page 554

All manuals and user guides at all-guides.com
5 - 44
HANDLEBAR
4. Install:
Collar 1
Throttle cables 2
To tube guide 3.
NOTE:
Apply the lithium soap base grease on the
throttle cable end and tube guide cable wind-
ing portion.
5. Install:
Throttle cable cap 1
Screw (throttle cable cap) 2
4 Nm (0.4 m · kg, 2.9 ft · lb)
Cover (throttle cable cap) 3
WARNING
After tightening the screws, check that the
throttle grip 4 moves smoothly. If it does
not, retighten the bolts for adjustment.
6. Install:
Brake master cylinder 1
Brake master cylinder bracket 2
Bolt (brake master cylinder bracket) 3
9 Nm (0.9 m · kg, 6.5 ft · lb)
NOTE:
Install the bracket so that the arrow mark a
faces upward.
First tighten the bolt on the upper side of the
brake master cylinder bracket, and then
tighten the bolt on the lower side.
CHAS