Yamaha WR250F Manuel D'atelier page 296

All manuals and user guides at all-guides.com
1
2 3
c
5
2
1
NOTE:
Install the bigger hook a of the spring fits on
the stopper b of the throttle shaft pulley.
4
b
NOTE:
a
e
d
NOTE:
While holding down the lever 1 2, insert the
push rod farthest into the carburetor.
4 - 15
CARBURETOR
7. Install:
Spring 1
Joint collar 2
To throttle shaft 3.
8. Install:
Throttle shaft assembly 1
Washer (metal) 2
Washer (resin) 3
Valve lever 4
Apply the fluorochemical grease on the bear-
ings.
Fit the projection a on the throttle shaft
assembly into the slot b in the throttle posi-
tion sensor.
Make sure the stopper c of the spring fits
into the recess in the carburetor.
Turn the throttle shaft assembly left while
holding down the lever 1 5 and fit the throt-
tle stop screw tip d to the stopper e of the
throttle shaft assembly pulley.
9. Install:
Push rod 1
ENG