Yamaha WR250F Manuel D'atelier page 546

All manuals and user guides at all-guides.com
5 - 40
FRONT FORK
4. Tighten:
Pinch bolt (upper bracket) 1
23 Nm (2.3 m · kg, 17 ft · lb)
Pinch bolt (lower bracket) 2
20 Nm (2.0 m · kg, 14 ft · lb)
CAUTION:
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
Brake hose holder 1
Brake caliper 2
Bolt (brake caliper) 3
23 Nm (2.3 m · kg, 17 ft · lb)
NOTE:
Fit the brake hose holder cut a over the pro-
jection b on the front fork and clamp the brake
hose.
6. Install:
Brake hose holder 1
Bolt (brake hose holder) 2
10 Nm (1.0 m · kg, 7.2 ft · lb)
Protector 3
Bolt (protector) 4
10 Nm (1.0 m · kg, 7.2 ft · lb)
NOTE:
When installing the brake hose holder, pass
the brake hose 5 in front of the axle boss a,
then fit it into the hose groove b so that the
brake hose does not contact the nut (wheel
axle).
7. Adjust:
Rebound damping force
NOTE:
Turn in the damping adjuster 1 finger-tight
and then turn out to the originally set position.
CHAS