ABB High dynamic performance HDP Serie Manuel D'installation, D'utilisation Et De Maintenance page 11

ENGLISH
Check:
• Motor "Type" code
• Rated voltage "Vn"
• Rated power "Pn"
• Rated speed "wn"
• Maximum speed "wm"
• Manufacturing details "IP"
• Cooling system rating
• Feedback device if present
• Data of the parking brake if present
1.3.2 Transportation and storage
The motor should always be stored indoors (above –20°C), in dry, vibration-free and dust-free conditions. During
transportation, shocks, falls and humidity should be avoided. In other conditions, please contact ABB.
In the case of liquid cooled motors, should they be used or stored in environments with the risk of sub-zero
temperatures, freezing of the liquid inside the motorsmust be prevented. This can be done either by emptying the
water jacket or by using anti- freeze additives. For more information, check Chapter 1.5.2 Cooling.
During transportation, shocks, falls and humidity should be avoided. In other conditions, please contact ABB.
Unprotected machined surfaces (shaft ends and flanges) should be treated against corrosion.
Rotating shafts periodically (once per quarter) by hand is recommended to prevent grease migration.
Using anti-condensation heaters is recommended, if fitted, to prevent water from condensing in the motor.
The motor must not be subject to any external vibrations at standstill to avoid causing damage to the bearings.
Motors fitted with cylindrical-roller and/or angular contact bearings must be fitted with locking devices during
transport.
When starting the motor for the first time, run the motor slowly for a brief run-in time.
1.3.3 Lifting
All ABB motors above 25 kg are equipped with lifting lugs or eyebolts.
Only the main eyebolts of the motor should be used to lift the motor. They must not be used to lift the motor when it
is attached to other equipment.
Lifting lugs for auxiliaries (e.g., brakes, separate cooling fans) or terminal boxes must not be used for lifting the
motor. Because of different output, mounting arrangements and auxiliary equipment, motors with the same frame
may have a different center of gravity.
Damaged eyebolts must not be used. Check that the eyebolts are undamaged before lifting.
Lifting eyebolts must be tightened before lifting. If required, the position of the eyebolt can be adjusted using
suitable washers as spacers.
Ensure that proper lifting equipment is used and that the sizes of the hooks are suitable for the lifting lugs.
Care must be taken not to damage auxiliary equipment and cables connected to the motor.
Remove eventual transport jigs fixing the motor to the pallet.
Specific lifting instructions are available from ABB.
WARNING:
1.3.4 Motor weight
The total weight of the machine can vary within the same frame size (center height) depending on the output,
mounting arrangement and auxiliaries.
During lifting, mounting or maintenance work, all necessary safety considerations
shall be in place and special attention to be taken that nobody will be subject to the
lifted load.
11