Publicité
Les langues disponibles
Les langues disponibles
be used as the Current Patient Document when powered on. Otherwise, the system uses the
Default Patient Document (PID: 0000000, No name) as the Current Patient Document when
powered on.
Touch Screen Calibration: Enters into touch screen calibration window. There are 5 cross cursors "
⚫
" on the screen, tab the cross point "
finish the calibration.
3.8.2 Setting the Date and Time
Select "Menu"→"System Settings"→"Date/Time".
Month/Day/Year/Hour/Minute/Second: to set system date and time.
⚫
Date format: Sets the date format of the system. There are 4 options: "YYYY-MM-DD",
⚫
"YYYY.MM.DD", "MM/DD/YYYY", "DD/MM/YYYY".
Current time: Refreshes the current system time.
⚫
3.8.3 Network Settings
Select "Menu"→"System Settings"→"Network".
Server IP Address: the IP address used to connecting a central monitoring system server (work
⚫
station) .
Port: the port number to which the monitor will connect to the work station in the central
⚫
monitoring system. Its setting range is from 6001 to 6064. It can also be used to represent the
patient bed number connecting to the work station. For example, the port number means the
monitor is assigned to the bed number 2 in the CMS. Our work station can connect to up to 64
bedside monitors, so please set the port between 6001and 6064. Press "OK" to make the new
setting effective.
HL7 Protocol: enable or disable the monitor to export data to CIS/HIS by HL7 protocol. Select it
⚫
means enable HL7 protocol. The default is "enabled" HL7 protocol.
Local IP Address: the local IP address for the device.
⚫
Subnet Mask: when the user selects a static IP address, then the subnet mask should be set. The
⚫
default subnet mask is "255.255.255.0".
Gateway: when the user selects a static IP address, then the gateway should be set. The default
⚫
gateway is "192.168.168.1".
Obtain IP Address Automatically: (when the remote server supports DHCP service) select it
⚫
means the IP address can be automatically configured by DHCP service. The device will perform
DHCP configuration on every device booting and/or network topology change. If select "Obtain IP
Address Automatically", then "Local IP Address", "Subnet Mask" and "Gateway" are in grey and
nonadjustable.
Note
If DHCP fails (that's to say, no DHCP server or no network is connected), then the IP
address will be changed as "0.0.0.0", and the network icon "
the lower right of the screen. If IP address is automatically configured by DHCP
successfully, then the IP address will be displayed and network icon will be changed
as "
If the network is disconnected later after a successful DHCP configuration (for
".
" of the 5 cross cursors with the stylus respectively to
28
" will be displayed on
Publicité
