Gima K10 Manuel D'utilisation page 102

13.3 CO Sensor Connection
2
13.3.1 Sidestream CO
1. Take out the CO Sensor and insert the CO
2
connector panel of the monitor;
2. The sample cell of the sampling cannula must be inserted into the sample cell receptacle of the CO
Sensor. A "click" sounds when the sample cell is inserted correctly, then connect to the airway tube.
After finishing sensor connection, and make sure that the air input end is exposed to room air and
away from all sources of CO
the CO switch at CO
2
3. Default Tubing Configuration
Sampling Dehumidification
adapter
Extending the airway tube for connecting to sampling tube (Single patient use)
Sensor Connection
2
Demonstration for Sidestream CO
, including the ventilator, the patient's breath, and your own. Next, turn on
2
Setup Screen and then wait 2 minutes for the sensor warm-up.
2
tubing
Adapter and Sampling tube (Single patient use)
Wye Connector
Sensor Connection
2
Sensor Cable into the connector labeled "CO
2
Sampling
Filter
tubing
90
" on the
2
Sampling cell
2