3.1 Installation
Warning
Devices connected to the equipment must meet the requirements of the applicable IEC
standards. The system configuration must meet the requirements of the IEC 60601-1-1
medical electrical systems standard. Any personnel who connect devices to the
equipment's signal input/output port are responsible for providing evidence that the safety
certification of the devices has been performed in accordance with IEC 60601-1-1. If you
have any questions, please contact the manufacturer or your local dealers.
If it is not evident from the equipment specifications whether a particular combination with
other devices is hazardous, for example, due to the summation of leakage currents,
please consult the manufacturer or an expert in the field, to ensure the proposed
combination does not impair patient safety and all devices concerned.
Caution
The equipment shall be installed by manufacturer-authorized personnel.
Note
The manufacturer solely owns the software copyright of the equipment. No organization or
individual shall resort to modifying, copying, or exchanging it or to any other infringement
on it in any form or by any means without due permission.
3.1.1 Unpacking and Checking
1. Open the package, take out the monitor and its accessories from the box and carefully place it in a safe,
stable, and easy to watch position.
2.
Open the user manual to sort the accessories according to the packing list.
Inspect the accessories for any mechanical damages
⚫
Check all the exposed leads and inserted accessories
⚫
Check whether any risk or abnormity exists in the device and its accessories before using the
⚫
monitor. If any abnormity (such as broken cable or crack of the enclosure) is found, do not use it
with the device.
Warning
When disposing of the packaging material, be sure to observe the applicable waste
control regulations and keep it out of children's reach.
Before use, please verify whether the package is intact, especially for the single use
accessories. In case of any damage, do not apply to patients.
Note
Chapter 3 Operating Instructions
19