Gima K10 Manuel D'utilisation page 92

SatSeconds icon and
sensitivity setting
Notes

When inserting finger into the probe cushion, then searching pulse icon "
the upper side of the SpO
finger is off, then icon "

When interference (caused by e.g., shaking finger) appears, then icon "
the upper middle side of the SpO
probe / finger is off, then icon "

The alarm will be triggered if the SpO
in one minute despite the Sat-seconds limit is not reached yet.
Below is the related alarm information for Nellcor SpO
No. Event
1 SpO INOP
2
2 SpO firmware error
2
3 Communication error
4 SpO faulty sensor
2
5 SpO hardware error
2
6 SpO module error
2
7 SpO sensor error
2
8 SpO sensor
2
disconnected
9 SpO probe off
2
panel. However, once the SpO
2
" will disappear.
panel. However, once the interference disappears, or
2
" will disappear.
measurements exceeds the limits totally three times
2
module.
2
Alarm level
High priority
alarm
Medium
priority alarm
80
"Interference" icon
/PR readings appear, or probe/
2
Remark
Such alarm will not display on alarm
information area, but it will be recorded
as alarm event which can be reviewed on
"Alarm event". these events are mostly
unrecoverable faults.
It means the SpO sensor identifications
2
fails.
The sensor cable or extension cable is not
connected to the monitor.
It means the sensor cable is connected,
but the probe is out of the measuring site.
" appears on
" appears on