Gima K10 Manuel D'utilisation page 49

5.2.1 General View
When powering on the monitor, it enters into the defaulted General View screen. (Please refer to the
monitor you purchased) There are 5 traces of waveform in the left view: waveform for ECG lead III, ECG lead
I, ECG lead II, SpO plethysmogram, and Respiration; And there are 5 panels in the right view: ECG, SpO
2
NIBP, RESP, and TEMP.
Description
General View screen shows data and waveforms of main parameters.
Generally, there are 5 traces of waveform in the waveform area. The default first trace is the
⚫
waveform for ECG lead II; The second is the waveform for ECG lead III; The third is the waveform
for ECG lead I; The fourth is the waveform for SpO
for Respiration. The user can change it as desired.
Generally, there are 5 parameter panels. The default panel order from up to down is HR, TEMP,
⚫
NIBP, SpO , RESP (or CO
2
General View Settings
➢ Waveform Settings
Settings of waveform channels and parameter panels can be changed easily. Wave 1, Wave 2, and Wave 3
can be set as any ECG lead, or turn off this channel directly.
If "3-lead wires" is selected, it is nonadjustable and fixed to be the current displayed cascaded waveform, it
can be set by Menu→ECG→Lead to change the current displayed ECG waveform (we will not cover it again).
The default is "ECG II".
Note

If "3-lead wires" is selected, then in all view settings (including general view, big font view,
all ECG trace view, NIBP list view and so on), the user can only be set it as the current
displayed ECG waveform (that's "ECGII", "ECGI" and "ECGIII").
If the checkbox "Cascaded above" is checked, Wave 1, Wave 2 and Wave 3 displays the same signal channel
as the trace in a cascaded way.
Wave 4 and Wave 5 can be set as "OFF", "SpO
).
2
", "RESP" and "CO
2
37
plethysmogram, And the fifth is the waveform
2
" and "CSM".
2
,
2