Gima K10 Manuel D'utilisation page 52

Short Trends View Settings
Waveform 1 to 3 can be set as OFF or ECG waves. The three ECG waves, if not set to "Off", should
⚫
be different from each other.
Waveform 4 to 5 can be set as OFF, SpO
⚫
Trend 1 is nonadjustable; the default is HR.
⚫
Trend 2 ~5 can be set as OFF, TEMP, SpO
⚫
Parameters 1 and 2 are nonadjustable; the default is ECG and SpO
⚫
Parameter 3~5 can be set as OFF, TEMP, NIBP, and RESP (or CO
⚫
5.2.7 CSM View
Description
In this view, the default waveform in the 4
are ECG, SpO and CSI respectively. Other waveform traces and parameters area can be set by user, refer to
2
the "CSM View Setting" for details.
The EEG waveform, SQI/EMG%/CSI/BS% trend graph and event mark can be displayed on CSM waveform
area, the EMG% real-time bar graph will be displayed as well. In above figure, "80" is the amplitude scale for
EEG, "-04.00 -03.00 -02.00 -01.00 -00:00" is the time scale for trend graph, and "0 20 40 60 80 100" is the
scale for CSI value.
CSM View Settings
Waveform 1 can be set as OFF or one ECG wave.
⚫
Waveform 2 to 3 can be set as OFF, SpO
⚫
respectively.
Waveform 4 is nonadjustable, the default is for EEG waveform and SQI/EMG%/CSI/BS% trend
⚫
graph.
Parameter 1, 2 and 5 are nonadjustable, the default is ECG, SpO
⚫
respectively.
Parameter 3 and 4 can be set as OFF, TEMP, NIBP, RESP (CO
⚫
CSM only: click it to turn on or off the CSM monitoring screen. If you click it to turn on "CSM only"
⚫
function, then waveform 1~3, and parameter 1~4 are fixed to be "off" and nonadjustable.
Waveform 4 and parameter 5 are fixed for CSM related function.
If you turn on "CSM only" function, then, the CSM view only displays EEG waveform, trend graphs and
parameters of CSI, EMG%, SQI and BS%, as shown in below figure.
and RESP (or CO
2,
, RR.
2
th
channel is for CSM related. The default in parameter 1, 2 and 5
and RESP (or CO
2
40
).
2
respectively.
2,
).
2
) etc. The default is "SpO
2
and CSI (Cerebral State Index)
2
) etc.
2
" and "RESP"
2