Publicité
Les langues disponibles
Les langues disponibles
Using Battery
The following steps should be followed to install the battery:
1
Open the battery cover.
2
Pull out the battery cable and connect it to the battery pack.
3
Push the battery pack into the battery compartment and lock it.
4
Close the battery cover.
Caution
It's better to recharge the battery after it is used up, and the charging time should be 12 to
15 hours.
The typical continuous operation time of the battery is no less than 120 minutes in the
power-saving mode.
Recharge the provided monitor battery after transportation or storage. If the monitor is
switched on without being connected to the AC power supply, it may not work correctly
due to insufficient battery power.
Note
When the device is working, it takes at least 10 hours to charge the battery from empty
state to 90% charged.
3.2.2 Turning the Monitor On
The system performs self-test and enters the initial display after the monitor is switched on, and the alarm
rings to inform the user that they can begin operating the monitor.
1.
Check all the applicable functions to make sure that the monitor works properly.
2.
If the built-in battery is applied, please recharge it after using the monitor to ensure sufficient power
storage. It takes at least 10 hours to charge the battery from depletion to a 90% charge.
3.
Press the Power on/off key on the front panel of the monitor to start the monitor.
Warning
Do not use this device to monitor the patient if there are indications of damage or
reminders of error. Please contact the local dealer or our company.
The battery-powered monitor continues to run without interruption when the AC mains
power is lost.
Caution
Start the monitor again 1 minute later after it is switched off. When the monitor is switched
off, allow one minute before switching it back on so that the monitor powers off correctly.
3.2.3 Starting Monitoring
1
Decide which parameter measurements you want to make.
21
Publicité
