CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 84

CAUTION
It should be remembered that certain effects resulting from the exposure of a product to environmental conditions are
the direct consequence of its exposure in sequence to two or more factors or parameters, among which are
particularly critical:
thermal shock, which may result from exposing the product to high temperature conditions immediately after
-
exposure to low temperature conditions or vice versa, or subjecting the product to water (rain, water jets, snow,
immersion, etc.) immediately after exposure to high temperature conditions;
the formation of ice, which may result from exposing the product to below-freezing temperatures immediately
-
before or after exposure to moisture, rain or water due to causes other than rain.
CAUTION
After storing the product within the limits of the above-mentioned conditions, it is required that it be kept in non-
operative condition for approximately 12 hours in order to re-establish the correct ambient temperature conditions
permitted so as to avoid damage to the electrical/electronic part as a result of thermal shock, ice formation or humidity,
etc., which may deteriorate or damage these circuits.
NOTE: any conditions other than the above may be indicated in the specific documentation of the components, where
present and supplied. In this case, the instructions in the specific documentation must be followed.
5.2 PRODUCT ASSEMBLY
The power unit covered by this manual must be assembled with the extension pole and the harvesting head to obtain
the complete tool for harvesting olives and coffee.
Start by mounting the power unit on the extension pole as shown below.
•
Engage the drive shaft connection on the handle gearmotor.
•
Insert the extension pole into the clamp until it stops in the body.
•
Tighten the four screws of the clamp to secure the extension pole firmly.
NOTE
The procedure for mounting the power units on the extension pole is the same for all available
models.
5.2.1 COMPONENT ASSEMBLY
Proceed with the mounting of the harvesting head on the extension pole as follows, making sure to first mount the
teeth or rakes as explained in the next paragraph.
•
Engage the drive shaft connection on the harvesting head shaft.
•
Insert the extension pole into the clamp until it stops in the body.
•
Tighten the clamp screws on the head to securely block the extension pole.
83 0310.0329 rev. 05