CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 70

IMPORTANT!
Under conditions of use with efforts beyond the maximum limit set on the control circuit board, a momentary
shutdown of the tool may occur (controlled by the electronics to prevent possible damage). Restarting takes
place after the tool has been removed from the branches and the ON-OFF switch on the control circuit board
has been turned off and on again.
CAUTION!
It is absolutely forbidden to start the engine of any vehicle with the product's power cable connected to the
battery via the cable clamps.
CAUTION!
It must be noted that the product was solely designed and built for the purposes mentioned above.
SAFETY
4.
4.1 GENERAL INFORMATION
It is the customer's responsibility to instruct personnel in charge of the use of the product on the risks of accidents,
safety devices and the general rules on accident prevention laid down by EU directives and the legislation of the
country where the product is used.
The personnel in charge must be familiar with the characteristics of the product.
They must also have read this manual and all the manuals mentioned in Chapter 9 (Annexes) in full.
Installation and maintenance work must be carried out by qualified personnel.
DANGER
Unauthorised tampering with or replacement of one or more parts of the product, the adoption of
accessories that change the use of the product, and the use of spare parts other than those
recommended may become a cause of risk of injury.
The installation and maintenance of the product must only be carried out by instructed and duly qualified personnel,
with the electrical, mechanical and pneumatic technical knowledge and any requirements valid at the site or in the
country where the product is used.
4.2 APPLIED DIRECTIVES AND TECHNICAL STANDARDS
Every product destined for countries within the European Union (EU), or countries for which there is an agreement
with the EU regarding product legislation, is supplied with a Declaration of Conformity in accordance with the
Machinery Directive 2006/42/EC.
The product supplied by CAMPAGNOLA S.r.l. does not belong to one of the categories of machinery listed in
Annex IV of Directive 2006/42/EC, therefore for the purposes of the attestation of conformity of the product with
the provisions of this directive, CAMPAGNOLA S.r.l. shall apply the conformity assessment procedure with internal
checks on the manufacture of the product as set out in Annex VIII of Directive 2006/42/EC
NOTE:
In the case of supplies of products in non-EU areas, unless otherwise contractually agreed between the parties,
Campagnola S.r.l., for the purposes of product design and manufacture, conforms for the applicable parts, and in
accordance with the state of the art, to the ISO, IEC standards applied.
The product has been designed, manufactured and tested in accordance with the following EU directives:
Machinery Directive 2006/42/EC concerning the approximation of the laws of the member states relating to
➢
machinery.
Electromagnetic Compatibility Directive 2014/30/EU (for products falling under it)
➢
Directives 2012/19/EU and 2011/65/EU
➢
Technical standards listed in the declaration of conformity.
➢
69 0310.0329 rev. 05