CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 88

Remove moving parts and separate, as far as possible, the various components by type of material (plastic, metal,
etc.), which must be disposed of through separate collection. Entrust the disposal of demolition materials to the
companies in charge.
Remove and handle the various parts of the product from the work area taking all necessary precautions
•
Always use the appropriate PPE for such operations and as indicated in Chapter 4.
•
After disassembling the product according to the previous procedure, the various materials must be separated and
disposed of in accordance with the regulations of the country in which the product is to be disposed of. The product
contains no hazardous components or substances requiring special removal procedures.
CAUTION
Extreme care must be taken because the possible falling of parts or components during removal can pose a
serious danger to operators.
NOTE
Disposal must be carried out in accordance with the legislation of the country in which the product is
installed. It is the user's obligation to comply with the regulations in force in his country.
NOTE
In the event of difficulties in the disassembly, demolition and dismantling of the components making up the
product, consult Campagnola Srl's design office, which will indicate the operating methods in compliance
with the principles of safety and environmental protection.
Please also refer to Chapter 4 regarding section "4.2.1 INDICATIONS FOR SPECIAL WASTE"
5.5.1 ADDITIONAL INFORMATION FOR BATTERY DISPOSAL
NOTE: For products equipped with battery packs or battery systems, please refer to the specific
documentation for their decommissioning or disposal.
6. USE AND OPERATION
6.1 GENERAL INFORMATION
- Only use the tool in good visibility conditions. A dimly lit work area may cause accidents. Do not perform cuts
in poor light conditions, like in the dark, at night, at dusk, at dawn or with dust or sand in the air impeding clear
visibility below 2 metres.
The areas in which the machine is used must have adequate lighting of 100 lux with a minimum uniformity of
0.7 over the work area and 50 lux, with uniformity of at least 0.3, in the immediate vicinity.
- Do not use the tool in hazardous conditions for the operator, on slippery ground and/or on steep slopes.
- Prior to use, inspect the work area and check that fallen processing waste cannot create damage or have a
significant effect on the safe use of the tool or create conditions of hindrance, tripping, etc.
- Always ensure correct posture (legs slightly apart with one foot in front of the other for greater force of action,
upright torso) respecting rest periods on use (one rest period per hour of work is suggested), on changeover
and position during work.
- Make sure not to get the product wet, immersed or in contact with water, snow, damp surfaces in general in
order to avoid damaging it.
- Keep children, frail persons, observers or animals at a safe distance and out of the product's range before
operating it in order to avoid damage, danger or injury.
- Keep the tool away from sources of heat, oil, solvents, and any environmental conditions other than those
indicated in the manual and permitted.
-
Attention is drawn to the fact that in the event of damage or other condition with leakage of battery fluid, there may
be risks to personnel in the event of contact or other situation resulting from such leakage. Do not touch any liquid
from the battery pack. In case of contact, rinse immediately with clean water. If the liquid comes into contact with
your eyes, rinse thoroughly with clean water and immediately seek medical attention.
-
Handle and use the product by gripping it completely and firmly with both hands to avoid misuse, injuries, falls
and accidental impacts.
87 0310.0329 rev. 05