CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 85

NOTE
The procedure for mounting the harvesting heads on the extension pole is the same for all
available models.
NOTE
All screws must be tightened with the appropriate torque. See paragraph 7.1.1.
To adjust the telescopic extension pole to the desired length, proceed as follows.
•
Unlock the lever (31) on the telescopic extension pole.
•
Adjust the length of the telescopic pole to the working height.
•
Lock the lever (31) to secure the telescopic tube firmly.
To complete the assembly of the product, it is now necessary to connect the power supply.
Use the power cable to connect the tool to the 12V lead o lithium battery (not included) and proceed as follows.
•
Insert the power cable connector into the slot of the handle.
•
Connect the power cable to the connector, respecting the male-female couplings and using the anti-error to
direct the connector PINs.
•
Make sure the ON-OFF switch is in the OFF position.
•
Connect the clamps to the battery, respecting the poles, or the power cable connector.
CAUTION!
The moment the ON-OFF switch is pressed in the ON position, the tool starts working immediately. Be
sure to position the tool away from people or property. Failure to comply with the warning is potentially
dangerous for operator safety.
84 0310.0329 rev. 05