Publicité
Les langues disponibles
Les langues disponibles
4.3
PRODUCT CERTIFICATION
The product comes with:
➢
Declaration of Conformity pursuant to Directive 2006/42/EC
➢
Declaration of Conformity pursuant to Directive 2014/30/EU
➢
Declaration of Conformity pursuant to Directives 2012/19/EU and 2011/65/EU
➢ The product is provided with a rating plate, as stated in par. 4.4
4.4
CE MARKING
The identification CE plate/label (Figure 1) is applied to each machine/tool.
The model, serial number and year of manufacture are shown on the manufacturer's CE plate and affixed on
the product. The CE plate is applied on the product/tool and shows the data and symbols described below:
1) CE conformity marking according to directive 2006/42/EC.
2) Company name and complete address of the manufacturer.
3) The compulsory requirement for all personnel in charge of use and/or maintenance of the tool to read the
use and maintenance manual.
4) Tool designation.
5) Type of tool - Type/code designation of the tool.
6) Serial number.
7) Year of manufacture, i.e. the year in which the manufacturing process was concluded.
8) Information pursuant to "WEEE" Directive 2012/19/EU: Electric and electronic waste may contain hazardous
substances for the environment and human health and therefore must not be disposed of with domestic
waste, they must be collected in dedicated collection centres.
9) Tool supply voltage (only for battery powered electrically supplied tools).
IMPORTANT!
To properly identify the tool, refer to the type, serial number and year of manufacture shown on the
identification plate and quote them to Campagnola Srl for any service. assistance or spare parts request.
IMPORTANT!
The CE marking is unique and it certifies the conformity of the product with the machinery directive and
the other applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a "composite" machine/tool a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx)
composing the composite machine/tool is affixed to the product.
IMPORTANT!
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the product/tool. Campagnola S.r.l declines any
responsibility on the safety of the product/tool in case of non-compliance with this prohibition.
The product label is placed on the product as shown in the following figure.
70
Figure 1
0310.0329 rev. 05
Publicité
