CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 87

The Icarus harvesting head is supplied with the teeth removed. Follow the procedure below to assemble them.
•
Remove the Icarus harvesting head and the eight teeth (20) from the packaging.
•
Insert the teeth with light pressure on the two supports (21), taking care that the reference planes are
correctly positioned and making sure that the locking teeth have come out of the support.
5.4 CHECKS AND VERIFICATIONS BEFORE START-UP
This paragraph sets out the checks and controls that must be carried out on the product before initial start-up.
•
Check that the handle and harvesting head are properly tightened on the extension pole.
•
Check that on the extension pole clamp, the lever (31) is in the locked position.
CAUTION
Before starting the product, carry out an integrity check of all its parts, including the battery.
Before use (see par. 6), make sure of the suitability of the battery for the specific product purchased.
5.5 DECOMMISSIONING
The following paragraph contains some tips and indications for the decommissioning, dismantling and removal of
the product at the end of its service life.
The following steps, as well as the instructions in the manuals of the components used, must be taken into
account when decommissioning.
The materials of which the product is made are essentially:
1) painted, plastic-coated or galvanised ferritic steel;
2) elastomers, PTFE, graphite;
3) gear oil;
4) motor;
5) electrical cables with associated conduits;
6) electronic control and actuation devices;
etc.
7)
After dismantling the product, the various materials must be separated and disposed of in accordance with the
regulations of the country in which the product is to be disposed of.
The operations described below are only permitted to authorised personnel:
Create sufficient space around the product to perform all movements without risk to personnel;
•
Disconnect the product's power sources;
•
Only after all of the above activities have been carried out, proceed to disassemble the product from top down and
paying special attention to the assemblies subject to falling by gravity.
86
ICARUS
0310.0329 rev. 05