CAMPAGNOLA POWER 58 Livret D'utilisation Et D'entretien page 92

7.1 PREVENTIVE OR ROUTINE MAINTENANCE
The routine maintenance operations listed below can be carried out by operators or maintenance technicians.
The Personal Protective Equipment provided for and to be used are in paragraph Chap. 1.7
7.1.1 TIGHTENING TORQUES
Screws and bolts of different types and sizes must be tightened during maintenance procedures.
The following tables show, depending on the type of screws and/or bolts present, the value of the maximum
tightening torque to be used and observed in order to avoid problems with the product.
Pos. Description
1 M4 screw
2 M5 screw
3 M4 screw
4 Screw Ø3.5
5 M5 screw
6 M5 screw
7 M5 screw
8 M4 screw
CAUTION
It is forbidden for the operator to carry out maintenance and/or tightening of screws and bolts reserved
for the mechanical maintenance technician or the electrical maintenance technician.
7.1.2 REPLACEMENT OF TEETH
The following section shows how to replace damaged teeth on the harvesting heads.
Replacement of ALICE harvesting head teeth
•
Remove the rake from the attachment (28) by unscrewing the 2 screws (26) securing the plate (25).
•
Shorten the damaged tooth (3) to approx. 2 cm.
•
Place the teeth support (21) on a vice and hit the tip of the tooth (20) with a hammer until it slides out of its
seat.
•
Insert the new tooth into place, taking care to butt the plastic tooth against the wall of the tooth support
•
Refit the rake to the attachment.
91
Function
They lock the power unit on the extension pole.
They lock the harvesting heads
ICARUS V1, HERCULES 6 and HOLLY on the
extension pole.
They lock the ALICE STAR harvesting heads
They lock power unit covers
They lock the ICARUS V1 and HERCULES 6 rake
support
They lock the rakes of the ALICE STAR harvesting
head
They lock ICARUS V1, HERCULES 6 and HOLLY
harvesting head covers
They lock ALICE STAR harvesting head covers
Qualified Tightening
personnel torque
4 Nm
5 Nm
4 Nm
1.5-2 Nm
5 Nm
5 Nm
5 Nm
4 Nm
0310.0329 rev. 05